Eicon Networks 1550 - Manual (Page 120)

Web Interface Settings Glossary 120
Primary number
Defines the primary phone number to dial. If the primary number is busy or otherwise
non-responsive, the secondary number is dialed. If no secondary number is defined,
the primary number is used again.
The phone number must include the characters "CR" followed by a prefix, and then the
telephone number. The choice of prefix depends on the operation of the local Data
Circuit-terminating Equipment (DCE). Normally, the N option is used. Note that the
V.25bis DCE will not dial if one of these prefixes is not properly chosen.
The following prefixes are available:
• N: The primary telephone number for the modem to dial.
• I: The primary telephone number provided with an identification number.
• S: The memory address for the modem to refer to.
Example: CRN5551234.
Max delay to establish connection
Defines the maximum delay permitted between dialing a number and achieving a
successful connection. This delay includes the dialing and handshake time between
external modems. If this timer is exceeded, the call is abandoned.
Range: 15-65 seconds. Default: 30.
Hangup delay
Defines the amount of time after the line is disconnected before a new command can
be issued. This is used to give the modem enough time to prepare to accept other
commands.
Range: 0-65 seconds. Default: 2.
DSR (on->off) transition delay
Defines the maximum delay for Data Set Ready (DSR) to be set to OFF after Data
Terminal Ready (DTR) is set to OFF. Normally DTR is set to OFF upon a disconnection
request.
Range: 0-65 seconds. Default: 2.
RI to DTR delay
Defines the amount of time between receipt of ring signal detection and the issuance
of Data Terminal Ready (DTR) on. If this delay is exceeded, the call is abandoned.
This delay must not exceed the value for SET V25BIS RING.
Range: 0-30000 milliseconds. Default: 1000.