Yaskawa F7 to L1000A - Manual (Page 56)

(Header Title) Application Note
Doc#: PL.L1000A.01 Copyright Yaskawa Electric America, Inc. ©2010 www.yaskawa.com September 9, 2010 56 of 57
Subject: Transition Guide Product: L1000A Document: PL.L1000A.01
Title: Product Transition Guide – F7 to L1000A
Product Transition Guide – F7 to L1000A
F7 L1000A
Parameter Name
Parameter Default
Setting
Record
Parameter Default
Comments: Gray shading indicates default setting.
Rescue Operation Torque
Limit
─ ─ S4-05 100.0 % ─
Rescue Operation Power
Supply Selection
─ ─ S4-06 0
L1000A
S4-06
0: Batterry
1: UPS (single-phase)
2: UPS (three-phase)
UPS Power ─ ─ S4-07 0.0 kVa Sets the capacity of the UPS.
UPS Operation Speed Limit
Selection
─ ─ S4-08 2
L1000A
S4-08
0: Disabled
1: Enabled until Light Load Detection Search is complete
2: Enabled until stop
DC Bus Voltage During
Rescue Operation
─ ─ S4-12 0 V ─
Rescue Operation Power
Supply Deterioration
Detection Level
─ ─ S4-13 80.0 %
Determines at which level of backup power supply
deterioration a PF5 fault is triggered.
Short Floor Operation
Selection
─ ─ S5-01 0
L1000A
S5-01
0: Disabled
1: Enabled (Short Floor)
2: Enabled (Advance Short Floor)
Nominal Speed for Short Floor
Calculation
─ ─ S5-02 0.0 %
When d1-18 is set for 0 or 3, S5-02 determines the rated
speed used during Short Floor.
Short Floor Minimum
Constant Speed Time
─ ─ S5-03 0.0 s
Sets the minimum operation time when Short Floor function
is enabled.
Distance Calculation
Acceleration Time Gain
─ ─ S5-04 150.0 % ─
Distance Calculation
Deceleration Time Gain
─ ─ S5-05 150.0 % ─
Stopping Method Selection ─ ─ S5-10 0
L1000A
S5-10
0: Disabled
1: Direct Landing
2: Leveling Distance Control
Deceleration Distance ─ ─ S5-11 0 mm ─
Stop Distance ─ ─ S5-12 0 mm ─
Short Floor
Opera
tion
Direct Landing Minimum
Speed Level
─ ─ S5-13 20.0 % Sets the speed level for the start of Direct Landing.
Motor Contactor Response
Error (Detection/Reset Select)
─ ─ S6-01 0
L1000A
S6-01
0: Detect during stop, SE1 manually reset
1: Detect during stop, SE1 automatically reset
2: No SE1 detection
Error De
te
ction
Starting Current Error (SE2)
Detection Delay Time
─ ─ S6-02 200 ms ─