Yaskawa F7 to L1000A - Manual (Page 45)

(Header Title) Application Note
Doc#: PL.L1000A.01 Copyright Yaskawa Electric America, Inc. ©2010 www.yaskawa.com September 9, 2010 45 of 57
Subject: Transition Guide Product: L1000A Document: PL.L1000A.01
Title: Product Transition Guide – F7 to L1000A
Product Transition Guide – F7 to L1000A
F7 L1000A
Parameter Name
Parameter Default
Setting
Record
Parameter Default
Comments: Gray shading indicates default setting.
Terminal A3 Function
Selection
H3-05 2 ─ ─
F7 L1000A
H3-05, H3-09 H3-02, H3-10
0: Terminal A1 bias 0: Terminal A1 Bias
1: Frequency gain ─
2: Auxiliary freq ref 1 2: Auxiliary freq ref 1
3: Auxiliary freq ref 2 3: Auxiliary freq ref 2
4: Output voltage bias ─
5: Accel/decel time gain ─
6: DC Injection Braking
current
─
7: Torque detection level ─
8: Stall Prevention level
during run
─
9: Output freq lower limit
level
─
A: Jump frequency ─
B: PID feedback ─
C: PID setpoint ─
D: Frequency bias 2 ─
E: Motor temperature input ─
F: Through- mode ─
10: FWD torque limit ─
11: REV torque limit ─
12: Torque limit during
regen
─
13: Torque ref/speed limit
during Torque Control
─
14: Torque compensation 14: Torque compensation
15: P/N both side torque
limit
─
─ ─
1F: Not used for analog
input 1F: Not used for analog
input
─ ─
Analog Inpu
t
Terminal A3 Gain Setting H3-06 100.0% ─ ─ No corresponding parameter in L1000A.
Terminal A2 Signal Level
Selection
H3-08 2 H3-09 0
F7 L1000A
H3-08 H3-09
0: 0 to 10 V
0: 0 to +10 V
(with lower limit)
1: -10 to 10 V 1: -10 to 10 V
2: 4 to 20 mA ─
Terminal A2 Function
Selection
H3-09 0 * H3-10 1F* *For L1000A, see table for A3 Function Selection
Terminal A2 Gain Setting
H3-10 100.0% H3-11 100.0%
F7 L1000A
Setting Range
0.0 % to 1000.0 %
-999.9 % to 999.9%
Terminal A2 Input Bias H3-11 0.0% H3-12 0.0%
F7 L1000A
Setting Range
-100.0 % to 100.0 %
-999.9 % to 999.9%
Analog Input Filter Time
Constant
H3-12 0.03 s H3-13 0.03 s