SMA WB 3600TL - Manual (Page 63)

SMA Solar Technology AG Restarting the system
Installation Guide WB36TL_50TL-IEN102011 63
4. Lock the bottom housing lid with the 6 screws.
Tighten the screws with 1.4 Nm torque in the order
shown in the figure on the right.
5. Check the Electronic Solar Switch for wear, as described in section 9.2 ”Checking the Electronic
Solar Switch (ESS) for Wear” (page 68).
6. If available, switch on the supply voltage of the multi-function relay.
7. Switch on the line circuit breaker.
8. Commission the small wind turbine system in accordance with the instructions of the
manufacturer.
CAUTION!
Damage to the Electronic Solar Switch by incorrect connection.
• Firmly connect the Electronic Solar
Switch.
• Check firm position of the Electronic
Solar Switch.
The handle of the
Electronic Solar Switch must be flush
with the housing.