SMA WB 3600TL - Manual (Page 57)

SMA Solar Technology AG Initial start-up
Installation Guide WB36TL_50TL-IEN102011 57
6.1.4 Restarting the Self-Test
In order to restart the self-test, proceed as follows:
1. Disconnect the line circuit breaker and secure against re-connection.
2. Disconnect the multi-function relay power supply, if available.
3. Disconnect the Electronic Solar Switch from the inverter for 5 minutes and then connect it again.
☑ The inverter is now in the initialization phase and you can restart the self-test, as described in
section 6.1.1 ”Starting the Self-Test by Tapping” (page 52) from point 3.
6.2 Display Messages during Initialization
• Firstly, the firmware version of the internal
processors appears in the text lines.
• After 5 seconds or after tapping the enclosure lid,
the serial number or the description of the inverter
appears. This description can be changed with a
communications device.
• After a further 5 seconds, or when you tap again,
the configured standard is displayed.
• After a further 5 seconds, or when you tap again,
the configured language is displayed.
• In normal operation the scrolling line of the display is subsequently empty. You can refer to the
possible event messages in the scrolling lines and their meaning in section 11 ”Messages”
(page 70).