HEIDENHAIN TNC 320 (340 551-02) - Manual (Page 486)

486
Comparison: Miscellaneous functions
M Effect TNC 320 TNC 310 iTNC 530
M00 Stop program/Spindle STOP/Coolant OFF X X X
M01 Optional program STOP X X X
M02 Stop program/Spindle STOP/Coolant OFF/Clear status display
(depending on machine parameter)/Go to block 1 X X X
M03
M04
M05 Spindle ON clockwise
Spindle ON counterclockwise
Spindle STOP X X X
M06 Tool change/Stop program run (machine-dependent function)/Spindle
STOP X X X
M08
M09 Coolant ON
Coolant OFF X X X
M13
M14 Spindle ON clockwise/Coolant ON
Spindle ON counterclockwise/Coolant ON X X X
M30 Same function as M02 X X X
M89 Vacant miscellaneous function or
Cycle call, modally effective (machine-dependent function) X X X
M90 Constant feed rate in corners – X X
M91 Within the positioning block: Coordinates are referenced to machine
datum X X X
M92 Within the positioning block: Coordinates are referenced to position
defined by machine tool builder, such as tool change position X X X
M94 Reduce the rotary axis display to a value below 360° X X X
M97 Machine small contour steps X X X
M98 Machine open contours completely X X X
M99 Blockwise cycle call X X X