HEIDENHAIN TNC 320 (340 551-02) - Manual (Page 421)

HEIDENHAIN TNC 320 421
12.1 MOD F
u
nctions
Overview of MOD functions
Depending on the selected mode of operation, you can make the
following changes:
Programming and Editing:
„
Display software numbers
„ Enter code number
„ Machine-specific user parameters (if provided)
Test Run:
„
Display software numbers
„ Show active tool table in the test run
„ Show active datum table in the test run
In all other modes:
„ Display software numbers
„ Select position display
„ Unit of measurement (mm/inches)
„ Programming language for MDI
„
Select the axes for actual position capture
„ Display operating times