HEIDENHAIN TNC 320 (340 551-02) - Manual (Page 358)

358 10 Programming: Q Parameters
1
0
.8 A
d
ditional F
u
nctions
2 Center misalignment in minor axis
54 - Spindle-orientation angle in degrees (center offset)
55 1 Rapid traverse
2 Probe feed rate
56 1 Maximum measuring path
2 Safety clearance
57 1 Oriented spindle stop possible
0 = no, 1 = yes
Reference point from touch
probe cycle, 360 1 1 to 9
(X, Y, Z, A, B, C,
U, V, W) Last reference point of a manual touch probe cycle, or
last touch point from Cycle without probe length
compensation but with probe radius compensation
(workpiece coordinate system)
2 1 to 9
(X, Y, Z, A, B, C,
U, V, W) Last datum of a manual touch probe cycle or last touch
point from cycle 0 without probe length or probe radius
compensation (machine coordinate system)
3 1 to 9
(X, Y, Z, A, B, C,
U, V, W) Result of measurement of the touch probe cycles 0 and
1 without touch probe radius and probe length
compensation
4 1 to 9
(X, Y, Z, A, B, C,
U, V, W) Last reference point of a manual touch probe cycle, or
last touch point from Cycle 0 without probe length
compensation but with probe radius compensation
(workpiece coordinate system)
10 - Spindle orientation
Value from the active datum
table in the active coordinate
system, 500 Line Column Read values
Read data of the current tool,
950 1 - Tool length L
2 - Tool radius R
3 - Tool radius R2
4 - Oversize in tool length DL
5 - Oversize in tool radius DR
6 - Oversize in tool radius DR2
7 - Tool locked TL:
0 = not locked, 1 = locked
8 - Number of replacement tool RT
9 - Maximum tool age TIME1
Group name, ID number Number Index Meaning