HEIDENHAIN TNC 320 (340 551-02) - Manual (Page 461)

HEIDENHAIN TNC 320 461
14.1 Mac
h
ine-Specific User P
a
ra
met
e
rs
Displaying help texts
The HELP key enables you to call a help text for each parameter object
or attribute.
If the help text does not fit on one page (1/2 is then displayed at the
upper right, for example), press the HELP PAGE soft key to scroll to the
second page.
To exit the help text, press the HELP key again.
Additional information, such as the unit of measure, the initial value, or
a selection list, is also displayed. If the selected machine parameter
matches a parameter in the TNC, the corresponding MP number is
shown.
Display Settings
Settings for screen display
Sequence of the displayed axes
CfgDisplayData
0: (key for the axis e.g. X)
1:
2:
3:
Settings for screen display Type of position display in the positioning window:
Type of position display in the status display:
Definition of decimal separator for position display:
Feed rate display in Manual/Elec. Handwheel operating mode:
Display of spindle position in the position display:
Display step for individual axes CfgPosDisplayPace
Display step for position display in mm or degrees:
Display step for position display in inches:
Definition of the units of measure valid for
the display CfgUnitOfMeasure
Unit of measure for display and user interface:
Format of NC programs and cycle display CfgProgramMode
Program input:
Display of cycles:
Settings of the NC and PLC dialogs CfgDisplayLanguage (MP7230)
NC dialog language:
PLC dialog language:
Language for PLC error messages:
Language for online help:
Behavior during control startup CfgStartupData
Acknowledge the „Power interrupted“ message: