HEIDENHAIN TNC 320 (340 551-02) - Manual (Page 479)

HEIDENHAIN TNC 320 479
Table of Miscellaneous Functions
M Effect Effective at block Start End Page
M00 Stop program/Spindle STOP/Coolant OFF „ Page 166
M01 Optional program STOP
„
Page 418
M02 Stop program/Spindle STOP/Coolant OFF/Clear status display
(depending on machine parameter)/Go to block 1 „ Page 166
M03
M04
M05 Spindle ON clockwise
Spindle ON counterclockwise
Spindle STOP „
„
„
Page 166
M06 Tool change/Stop program run (machine-dependent function)/Spindle STOP
„
Page 166
M08
M09 Coolant ON
Coolant OFF „
„
Page 166
M13
M14 Spindle ON clockwise/Coolant ON
Spindle ON counterclockwise/Coolant ON
„
„
Page 166
M30 Same function as M02 „ Page 166
M89 Vacant miscellaneous function or
Cycle call, modally effective (machine-dependent function) „
„
Page 185
M91 Within the positioning block: Coordinates are referenced to machine datum „ Page 167
M92 Within the positioning block: Coordinates are referenced to position defined by machine
tool builder, such as tool change position „ Page 167
M94 Reduce the rotary axis display to a value below 360°
„
Page 179
M97 Machine small contour steps „ Page 169
M98 Machine open contours completely
„
Page 171
M99 Blockwise cycle call „ Page 185