Grass Valley K2 (Summit 3G) 10Gv2 Storage Area Network Installation v.8.1 - Manual (Page 70)

10. Click Modify Selected Ports .
11. Make sure Port Enabled is set to Yes , leave Mode as default of Auto .
12. Set Flow Control as follows:
Set to Disable .
13. Click Apply Settings .
Wait until settings are applied and the Web interface becomes active.
14. Proceed as follows:
• If the switch carries no media (iSCSI) traffic, such as for a Nearline system, there is no need
to configure VLANs. Skip to the end of this procedure.
• If the switch carries media (iSCSI) traffic, then it must have VLANs configured. Continue
with the next step in this procedure.
70 K2 SAN Installation and Service Manual 02 February 2012
Setting up the K2 SAN infrastructure