Grass Valley K2 (Summit 3G) 10Gv2 Storage Area Network Installation v.8.1 - Manual (Page 187)

2. In the K2Config application tree view, under the K2 Media Server select the File System Server
node.
The File System Server Configuration page appears.
3. Click Check and verify that the V: drive is shared.
Next, configure K2 clients and/or other iSCSI clients on the K2 SAN.
Configuring the basic nearline K2 SAN
Work through the topics in this section sequentially to configure a non-redundant nearline (Tier 3)
K2 SAN.
Prerequisites for initial configuration - Basic nearline K2 SAN
Before beginning your initial configuration, make sure the devices of the K2 SAN meet the following
prerequisites.
Control point PC
• Ethernet cable connected
• Control Point software installed
• Control network IP address assigned
• Network communication over the control network with all other K2 devices
• Power on
Ethernet switch
• Ethernet cables connected
• Control network IP address assigned
• VLANs set up
• Trunks set up
• Power on
K2 Media Server
• Ethernet cables connected
• Fibre Channel cable connected
• Software installed, as from the factory, including QuickTime 7
• Control network IP address assigned
• Power on for all servers
K2 RAID chassis
• Fibre Channel cable(s) connected
• Ethernet cable(s) connected
02 February 2012 K2 SAN Installation and Service Manual 187
Configuring and licensing the K2 SAN