Creating a new file system - redundant k2 san – Grass Valley K2 (Summit 3G) 10Gv2 Storage Area Network Installation v.8.1 User Manual
Page 166
10. Click
OK
to close the Bind dialog box and begin the binding process.
The Progress Report dialog box opens, showing the status of the binding process.
11. Close the Progress Report and repeat these steps for other unbound disks.
If specified by your system design, you can bind some disks as Hot Spares.
When you are done, if you did not bind any extra Hot Spares, you should have the following
results:
For redundant storage, on the primary RAID chassis you should have two RAID 1 RANKs of
two disks each, one Hot Spare Disk, and one RAID 5 or RAID 6 RANK of six disks. For each
optional Expansion chassis, you would have an additional one or two RAID 5 or RAID 6 RANKs
of six disks each.
12. Click
Close
in Progress Report window.
13. Restart the K2 Media Server.
NOTE: Make sure start up processes on the K2 Media Server are complete before proceeding.
Next, create a new file system.
Related Topics
on page 321
on page 325
on page 327
Creating a new file system - Redundant K2 SAN
Prerequisites for the K2 RAID chassis are as follows:
•
Fibre Channel cable(s) connected
•
Ethernet cable(s) connected
•
Power on
•
Disks bound
Prerequisites for the optional K2 RAID Expansion chassis are as follows:
•
Fibre channel cable(s) connected
166
K2 SAN Installation and Service Manual
02 February 2012
Configuring and licensing the K2 SAN