Grass Valley K2 (Summit 3G) 10Gv2 Storage Area Network Installation v.8.1 User Manual
Page 307
This task required a restart.
You can use the K2Config application to configure multicast settings on all the K2 Summit systems
attached to a K2 SAN. Refer to related topics in "K2 System Guide" for live streaming technical
details.
1. On the PC that hosts K2Config, open the K2Config application.
A login dialog box opens.
2. Log in to the K2Config application with the administrator account.
The K2Config application opens.
3. In the K2Config application tree view, select each K2 Summit system attached to the K2 SAN
and verify that the
Write Filter Enabled
setting shows that the write filter is not enabled on the
K2 Summit system.
4. In the K2Config application tree view, select the name of the K2 SAN, which is the top node of
the storage system tree.
The SAN summary information is displayed.
5. Select the multicast IP base.
The K2 Summit system applies channel-specific IP addresses from this base.
Your choices are constrained to those specified by IANA for multicast.
02 February 2012
K2 SAN Installation and Service Manual
307
Administering and maintaining the K2 SAN