Grass Valley K2 (Summit 3G) 10Gv2 Storage Area Network Installation v.8.1 - Manual (Page 120)

16. On the Restored Partition Type page, leave the selection at Primary and then click Next .
17. On the Restored Partition Size page, leave settings at their defaults. The size reported in the
upper pane is the size detected of the actual D: partition. This should be the same as that reported
in the Partition size field in the middle of the page. Free space before and Free space after should
both be reported at 0 bytes. Click
Next .
18. On the Next Selection page, select No, I do not and then click Next .
19. On the Restoration Options page, do not make any selections. Click Next .
20. On the “…ready to proceed…” page, verify that you are restoring the correct image to the correct
location. Click Proceed .
21. On the Operation Progress page, observe the progress report.
22. When a “The data was successfully restored” message appears, click OK .
23. Click Operations | Exit to exit the Acronis True Image program.
The machine restarts automatically.
24. Remove the recovery media while the machine is shutting down.
Restoring from the generic recovery disk image on E:
There can be multiple versions of the generic recovery disk image on the server’s E: partition. Refer
to related topics in "K2 Release Notes" to determine which version you should use.
This procedure can be used on a server that needs to be restored to its factory default state. For
example, if you neglected to make a first birthday image, you might need to use this procedure. If
the image from which you are restoring was made from the specific machine, refer to the appropriate
procedure.
NOTE: This procedure restores the server (both C: and D: partitions) to its factory default
condition. Passwords and other site-specific configurations are reset to factory defaults.
1. Make sure that media access is stopped and that the system on which you are working is not
being used.
2. Connect all motherboard NICs to LAN connections.
3. If the server has a 10 Gig connection, make sure it is connected to the 10 Gig connection on the
Ethernet switch.
If not connected to a switch, 10 Gig network adapter detection and ordering are unpredictable
on the restored image.
4. If you have not already done so, connect keyboard, monitor, and mouse.
5. Do the following:
a) Insert the Recovery CD.
b) Restart the machine.
If there is a problem restarting, hold the standby button down for five seconds to forced a
hard shutdown. The press the standby button again to startup.
The system boots from the Recovery CD.
The Acronis program loads.
6. At the startup screen, select True Image Server OEM (Full Version) .
The Acronis main window appears.
120 K2 SAN Installation and Service Manual 02 February 2012
Managing K2 Software