Installing the k2 system on the rack mount rails, Making rack slide adjustments – Grass Valley K2 System Guide v.9.0 User Manual
Page 270

Installing the K2 system on the rack mount rails
1. Pull the slide-out track section to the fully extended position.
WARNING: To prevent injury, two people are required to lift the K2 system. It is too heavy
for one person to install in the rack.
WARNING: To prevent serious injury, ensure that the rack is anchored to the floor so
that it cannot tip over when the K2 system is extended out of the rack.
2. Push the chassis toward the rack until the chassis sections meet the locking bracket.
3. Verify the cabinet is pushed fully into the rack.
4. Insert and tighten the front panel retaining screws as shown in the previous diagram.
Making Rack Slide Adjustments
After installation, binding may occur if the slide tracks are not properly adjusted. To adjust the
tracks:
1. Slide the chassis out approximately 10 inches.
2. Slightly loosen the mounting screws holding the tracks to the front of the rails and allow the
tracks to seek an unbound position.
3. Tighten the mounting screws and check the tracks for smooth operation by sliding the chassis
in and out of the rack several times.
4. Tighten the front panel retaining screws once the cabinet is in place within the rack to complete
the installation.
270
K2 System Guide
06 November 2012
Rack mounting