Ltc input/output, Vitc input/output, Ltc input/output vitc input/output – Grass Valley K2 System Guide v.9.0 User Manual
Page 222

Specification
Parameter
4 Channels per video output.
Audio mapping is direct and fixed. AES outputs are active at all
times.
Audio is output using a 48kHz clock derived from the video
reference.
Supports 16- or 24-bit media.
On playout, audio is synchronized with video as it was recorded.
Compatible with AC-3 and Dolby-E
Audio Outputs
110 ohms, balanced
Input Impedance
Configurable relative to video for both record and playout.
Audio time shift
LTC Input/Output
The K2 Summit/Solo system specification is shown in the following table
Specification
Parameter
SMPTE 12M Longitudinal Time Code, AC coupled, differential
input
Standard
1 per video input - Shared 6 pin conn. with output
Number of Inputs
1 per video output
Number of Outputs
1K ohm
Input Impedance
110 ohm
Output Impedance
0.1 V peak-to-peak, differential
Minimum Input Voltage
2.5 V peak-to-peak, differential
Maximum Input Voltage
2.0 V peak-to-peak differential.
Nominal Output Voltage
LTC reader will accept LTC at rates between 1/30 and 80 times the
nominal rate in either forward or reverse directions.
LTC Reader
LTC transmitter outputs LTC at the nominal frame rate for the
selected standard at 1x speed, forward direction only.
LTC Transmitter
VITC Input/Output
The K2 Summit/Solo system specification is shown in the following table.
222
K2 System Guide
06 November 2012
Specifications