Amer Networks SS2R48G4i V2 - Manual (Page 67)

SS2R24G4i/SS2R48G4i
56
5.4.6.1.7 show snmp mib
Command show snmp mib
Function Display all MIB supported by the switch
Command Mode Admin Mode
5.4.6.1.8 debug snmp packet
Command debug snmp packet
no debug snmp packet
Function Enable the SNMP debugging; the “no debug snmp packet” command disables the
debugging function
Command Mode Admin Mode
5.4.6.2 SNMP Troubleshooting
When users configure the SNMP, the SNMP server may fail to run properly due to physical
connection failure and wrong configuration, etc. Users can troubleshoot the problems by following the
guide below
z Good condition of the physical connection.
z Interface and datalink layer protocol is Up (use the “show interface” command), and the
connection between the switch and host can be verified by ping ( use “ping” command).
z The switch enabled SNMP Agent server function (use “snmp-server” command)
z Secure IP for NMS (use “snmp-server securityip” command) and community string (use
“snmp-server community” command) are correctly configured, as any of them fails, SNMP will
not be able to communicate with NMS properly.
z If Trap function is required, remember to enable Trap (use “snmp-server enable traps”
command). and remember to properly configure the target host IP address and community
string for Trap (use “snmp-server host” command) to ensure Trap message can be sent to the
specified host.
z If RMON function is required, RMON must be enabled first (use “rmon enable” command).
z Use “show snmp” command to verify sent and received SNMP messages; Use “show snmp
status” command to verify SNMP configuration information; Use “debug snmp packet” to
enable SNMP debug function and verify debug information.
z If users still can’t solve the SNMP problems, Please contact our technical and service center.
5.5 Switch Upgrade
SS2R24/48G4i switch switch provides two ways for switch upgrade BootROM upgrade and the
TFTP/FTP upgrade under Shell