Amer Networks SS2R48G4i V2 - Manual (Page 184)

SS2R24G4i/SS2R48G4i
173
21.2 Typical SNTP Configuration Examples
SW1 SW2 SWn
Fig 21-1 Typical SNTP Configuration
All SS2R24/48G4i switch switch in the autonomous zone are required to perform time synchronization,
which is done through two redundant SNTP/NTP servers. For time to be synchronized, the network
must be properly configured. There should be reachable route between any SS2R24/48G4i switch
switch and the two SNTP/NTP servers.
Example Assume the IP addresses of the SNTP/NTP servers are 10.1.1.1 and 20.1.1.1, respectively,
and SNTP/NTP server function (such as NTP master) is enabled, then configurations for any
SS2R24/48G4i switch switch should like the following
Switch #config
Switch (config)#sntp server 10.1.1.1
Switch (config)#sntp server 20.1.1.1
From now on, SNTP would perform time synchronization to the server according to the default setting
(polltime 64s, version 1).