Amer Networks SS2R48G4i V2 - Manual (Page 171)

SS2R24G4i/SS2R48G4i
160
Switch(dhcp-A-config)#netbios-name-server 10.16.1.209
Switch(dhcp-A-config)#netbios-node-type H-node
Switch(dhcp-A-config)#exit
Switch(Config)#ip dhcp excluded-address 10.16.1.200 10.16.1.210
Switch(Config)#ip dhcp pool B
Switch(dhcp-B-config)#network 10.16.2.0 24
Switch(dhcp-B-config)#lease 1
Switch(dhcp-B-config)#default-route 10.16.2.200 10.16.2.201
Switch(dhcp-B-config)#dns-server 10.16.2.202
Switch(dhcp-B-config)#option 72 ip 10.16.2.209
Switch(dhcp-config)#exit
Switch(Config)#ip dhcp excluded-address 10.16.2.200 10.16.2.210
Switch(Config)#ip dhcp pool A1
Switch(dhcp-A1config)#host 10.16.1.210
Switch(dhcp-A1-config)#hardware-address 0003.2223.dcab
Switch(dhcp-A1-config)# client-name
management
Switch(dhcp-A1-config)#exit
Usage Guide When a DHCP/BootP client is connected to a VLAN1 port of the switch, the client can
only get its address from 10.16.1.0/24 instead of 10.16.2.0/24. This is because the broadcast packet
from the client will be requesting the IP address in the same segment of the VLAN interface after VLAN
interface forwarding, and the VLAN interface IP address is 10.16.1.2/24, therefore the IP address
assigned to the client will belong to 10.16.1.0/24.
If the DHCP/BootP client wants to have an address in 10.16.2.0/24, the gateway forwarding broadcast
packets of the client must belong to 10.16.2.0/24. The connectivity between the client gateway and the
switch must be ensured for the client to get an IP address from the 10.16.2.0/24 address pool.
18.3 DHCP Troubleshooting
18.3.1 Monitor and Debug Commands
18.3.1.1 clear ip dhcp binding
Command clear ip dhcp binding {
Function Deletes the specified IP address-hardware address binding record or all IP
address-hardware address binding records.
Parameters
IP addresses that have a binding record.
Command mode Admin Mode
Relative Command show ip dhcp binding
18.3.1.2 clear ip dhcp conflict