Amer Networks SS2R48G4i V2 - Manual (Page 26)

SS2R24G4i/SS2R48G4i
15
Chapter 3 Setup Configuration
Setup configuration refers to the initial operation to the switch after the user purchases the switch.
For first-time users of the SS2R24/48G4i switch, this chapter provides a very practical instruction.
When using the CLI (command line interface), the user can type setup under admin mode to enter the
Setup configuration interface.
3.1 Setup Configuration
Setup configuration is done via menu selections, in which switch hostname, Vlan1 interface, Telnet
service, Web service,and SNMP, can be configured.
3.2 Main Setup Menu
Before entry into the main menu, the following screen will be displayed to prompt the user to select
a preferred interface language. English users should choose “0” to enter the English interface, while
Chinese users can choose “1” to view the interface in Chinese.
Please select language
[0] English
[1] Chinese
Selection(0|1)[0]
The main Setup configuration menu is listed below
Configure menu
[0] Config hostname
[1] Config interface-Vlan1
[2] Config telenet-server
[3] Config web-server
[4] Config SNMP
[5] Exit setup configuration without saving
[6] Exit setup configuration after saving
Selection number
3.3 Setup Submenu
3.3.1 Configuring switch hostname
Select “0” in the Setup main menu and press Enter, the following screen appears
Please input the host name[switch]
Note the hostname entered should be less than 30 characters. If the user presses Enter without
input, the hostname will default to “switch”