Amer Networks SS2R48G4i V2 - Manual (Page 39)

SS2R24G4i/SS2R48G4i
28
4.2.1.1.2 Admin Mode
When enable command is used under User Mode,To Admin Mode sees the following In user
entry system, if as Admin user, it is defaulted to Admin Mode. Admin Mode prompt “Switch#” can be
entered under the User Mode by running the enable command and entering corresponding access
levels admin user password, if a password has been set. Or, when exit command is run under Global
Mode, it will also return to the Admin Mode. SS2R24/48G4i switch Switch also provides a shortcut key
sequence "Ctrl+z”, this allows an easy way to exit to Admin Mode from any configuration mode (except
User Mode).
Under Admin Mode, the user can query the switch configuration information, connection status and
traffic statistics of all ports; and the user can further enter the Global Mode from Admin Mode to modify
all configurations of the switch. For this reason, a password must be set for entering Admin mode to
prevent unauthorized access and malicious modification to the switch.
4.2.1.1.3 Global Mode
Type the config command under Admin Mode will enter the Global Mode prompt “Switch(Config)#”.
Use the exit command under other configuration modes such as Interface Mode, VLAN mode will return
to Global Mode.
The user can perform global configuration settings under Global Mode, such as MAC Table, Port
Mirroring, VLAN creation, IGMP Snooping start, GVRP and STP, etc. And the user can go further to
Interface Mode for configuration of all the interfaces.
4.2.1.1.4 Interface Mode
Use the interface command under Global Mode can enter the interface mode specified.
SS2R24/48G4i switch Switch provides three interface type VLAN interface, Ethernet port and
port-channel, and accordingly the three interface configuration modes.
Interface
Type
Entry Prompt Operates Exit
VLAN
Interface
Type interface
vlan
command under
Global Mode.
Switch(Config-If-
Vlanx)#
Configure
switch IPs, etc
Use the exit
command to
return to
Global Mode.
Ethernet Port Type interface
ethernet
command under
Global Mode.
Switch(Config-
ethernetxx)#
Configure
supported
duplex mode,
speed, etc.
of Ethernet
Port. Use the exit
command to
return to
Global Mode.
port-channel Type interface
port-channel Switch(Config-if-
port-channelx)#
Configure
port-channel Use the exit
command to