Amer Networks SS2R48G4i V2 - Manual (Page 165)

SS2R24G4i/SS2R48G4i
154
speed_type Port speed type 10Mbps, 100Mbps, 1,000Mbps and
10Gbps.
duplex_type Port duplex mode full-duplex and half-duplex
port_type Port VLAN property access port or trunk port
mux_state Status of port binding status machine
rcvm_state Status of port receiving status machine
prm_state Status of port sending status machine
3. Display load balance information for port-group 1.
4．Display member port information for port-group 1.
Displayed information Explanation
portnumber Port number
port priority Port Priority
system System ID
system priority System Priority
LACP activety Whether port is added to the group in “active” mode, 1 for yes.
LACP timeout Port timeout mode, 1 for short timeout.
Aggregation Whether aggregation is possible for the port, 0 for
independent port that does not allow aggregation.
Synchronization Whether port is synchronized with the partner end.
Collecting Whether status of port bound status machine is “collecting” or
not.
Distributing Whether status of port bound status machine is “distributing”
or not.
Defaulted Whether the local port is using default partner end parameter.
Expired Whether status of port receiving status machine is “expire” or
not.
Selected Whether the port is selected or not..
5．Display port-channel information for port-group1
Displayed information Explanation
Port channels in the
group If port-channel does not exist, the above information will not
be displayed.
Number of port Port number in the port-channel.
Standby port Port that is in “standby” status, which means the port is
qualified to join the channel but cannot join the channel due to
the maximum port limit, thus the port status is “standby”
instead of “selected”.
17.4.1.2 debug lacp