Amer Networks SS2R48G4i V2 - Manual (Page 163)

SS2R24G4i/SS2R48G4i
152
Scenario 2 Configuring Port Channel in ON mode.
S1
S2
Fig 17-3 Configuring Port Channel in ON mode
Example As shown in the figure, ports 1, 2, 3 of Switch1 are access ports that belong to vlan1. Add
those three port to group1 in “on” mode. Ports 6, 7, 8 of Switch2 are trunk ports that also belong to
vlan1, and allow all,and add the these four ports to group2 in “on” mode
The configuration steps are listed below
Switch1#config
Switch1 (Config)#interface eth 0/0/1
Switch1 (Config-Ethernet0/0/1)# port-group 1 mode on
Switch1 (Config-Ethernet0/0/1)#exit
Switch1 (Config)#interface eth 0/0/2
Switch1 (Config-Ethernet0/0/2)# port-group 1 mode on
Switch1 (Config-Ethernet0/0/2)#exit
Switch1 (Config)#interface eth 0/0/3
Switch1 (Config-Ethernet0/0/3)# port-group 1 mode on
Switch1 (Config-Ethernet0/0/3)#exit
Switch2#config
Switch2 (Config)#port-group 2
Switch2 (Config)#interface eth 0/0/6
Switch2 (Config-Ethernet0/0/6)#port-group 2 mode on
Switch2 (Config-Ethernet0/0/6)#exit
Switch2 (Config)# interface eth 0/0/8-9
Switch2 (Config-Port-Range)#port-group 2 mode on
Switch2 (Config-Port-Range)#exit
Configuration result
Add ports 1, 2, 3 of Switch 1 to port-group 1 in order, and we can see a group in “on” mode is
completely joined forcedly, switch in other ends won’t exchange LACP BPDU to complete aggregation.
Aggregation finishes immediately when the command to add port 2 to port-group 1 is entered, port 1
and port 2 aggregate to be port-channel 1, when port 3 joins port-group 1, port-channel 1 of port 1 and 2