Amer Networks SS2R48G4i V2 - Manual (Page 159)

SS2R24G4i/SS2R48G4i
148
16.5.1.1 show am
Command show am [interface ]
Function Display the address entries configured on the current switch.
Parameters interfaceName name of the physical interface
Command Mode Global configuration mode
Default Setting None
Displayed information Explanation
Global AM is enabled AM is enabled
am mac-ip-pool 00-00-00-00-00-13
100.1.1.2 USER_CONFIG Only the users whose source MAC ＝
00-00-00-00-00-13 and source IP=100.1.1.2
can pass, this is configured by users.
am mac-ip-pool 00-00-00-00-01-12
100.1.1.1 USER_CONFIG Only the users whose source MAC ＝
00-00-00-00-01-12 and source IP=100.1.1.1can
pass, this is configured by users.
am ip-pool 10.1.1.1 8 USER_CONFIG Only the users whose source IP=10.1.1.1 ～
10.1.1.8 can pass, this is configured by users.
16.5.2 AM Troubleshooting
& Since there is only limited hardware resources for AM, each port can configure 507 entries at most.
& The AM resource requires that the IP addresses and MAC addresses configured by users cannot
conflict, that is the different users on the same switch cannot have the same IP or MAC
configuration.