Welltech VoIP ATA series V.2.1 - Manual (Page 39)

ATA-171/172/171P/171M/171+/172+
User’s Guide
digits number, can be numbers or signs (+, x). (+) means “Or”;
(x) means any numbers that is from 0~9.
Drop Prefix Default: No (Encode). When encountering the accordant rule, a
new number will be added in front of the dialing number. When
setting YES, and encountering the accordant rule, a new number
will replace the dialing number.
Replace rule3 Providing the setting number information. 7 digits number is
preferred, from (0~9999999). . Maximum length is 8 bytes.
+ Provides the rules for encode and decode. Maximum length is 31
digits number, can be numbers or signs (+, x). (+) means “Or”;
(x) means any numbers that is from 0~9. . Maximum length is
40 bytes.
Drop Prefix Default: No (Encode). When encountering the accordant rule, a
new number will be added in front of the dialing number. When
setting YES, and encountering the accordant rule, a new number
will replace the dialing number.
Replace rule4 Providing the setting number information. 7 digits number is
preferred, from (0~9999999) . Maximum length is 8 bytes.
+ Provides the rules for encode and decode. Maximum length is 31
digits number, can be numbers or signs (+, x). (+) means “Or”;
(x) means any numbers that is from 0~9. . Maximum length is
40 bytes.
Dial Now Provides the rules for encode and decode. Maximum length is 31
digits number, can be numbers or signs (+, x). (+) means “Or”;
(x) means any numbers that is from 0~9.
But the first digit
cannot be “0”. Because 0 cannot judge the rule. So if Dial
Now begins with “0”, the system cannot work.
. Maximum
length is 124 bytes.
Auto Dial Time Default: 5 second. After waiting for a while, but didn’t input any
number, Auto Dial will run automatically. Time zone: (3~9 sec). .
Maximum length is 3 bytes.
Use # for send
key Default: YES. It ends with # when execute this action. When
setting NO, it didn’t end with # when execute this action, but
according with Auto Dial Time, after waiting for a while, and
didn’t input any information, then execute this action.
Use * for IP
dialing
Default YES. When input “*”, it will used as “.”. E.g. When input
192*168*1*100#, it execute”192.168.1.100#”. When setting
NO, while dialing, input (*) doesn’t mean (.).
Submit [Button] Submit the change.
Reset [Button] Clear the change.
Figure 2: Phone / FXS + FXO equipment