Welltech VoIP ATA series V.2.1 - Manual (Page 32)

ATA-171/172/171P/171M/171+/172+
User’s Guide
5.6.1 Caller ID (for FXS Port)
5.6.1 Function
Caller ID Setting provides Caller ID, Single Caller ID, CID without Time, CID Type 2
5.6.2 Instruction
Figure Caller ID Setting (VoIP Gateway Only)
Caller ID Default: Caller ID after 1st Ring (FSK). After 1 st Ring, the Caller
ID will be forwarded. Providing Don’t show caller ID, Caller ID
after 1st Ring (FSK), Caller ID before 1st Ring (FSK), Caller ID
berofr 1st Ring (DTMF) Items for choosing.
Signal Caller ID Default NO. When setting ON, Caller ID, Call Out No. and date
will be shown on the LCD.
Single Caller ID: only contain Caller ID (without Name and
Date/Time).
According to Telcordia specifications, CND signaling starts as
early as 300 mS after the first ring burst and ends at least 475
mS before the second ring burst
CID Without Time Default: NO. When setting Yes, only caller ID will be shown.
CID Type 2
Default: No. When setting ON, and during a call, a new call also
comes; the new call’s ID will be shown on the LCD.
Needs the HW’s support.
Submit [Button] Submit the change.
Reset [Button] Clear the change.
5.6.3 Operate Instruction
Step 1
: On the main page, select [Phone SettingCaller ID Setting], enter [Caller ID Setting]
page, after revising information (e.g. Caller ID: Don’t show caller id) (See Figure 1), then
click [Submit].