Verilink SCM (880-503300-001) Product Manual - Manual (Page 77)

Downloading and Broadcasting Firmware
Verilink SCM 6-13
Press E NTER to display the SCM Download Firmware Menu.
If an ACP module did not receive a good load, the Card Re-transmit
function may be used to specifically target QUAD DATA modules.
For modules other than the QUAD DATA module, targeted
download can be done by changing the logical position to the
administration of the module to be downloaded and use the F)
Download from firmware from near end SCM option.
Card Retransmit Each time Card Retransmit is used on a module, it will force a
download to that module, even if a retransmit to that module has
already been requested.
When using the Card Retransmit option to resend to a number of
modules, avoid entering a command string longer than 128
characters. Any input after the 128th character will be lost.
When all modules targeted by the Card Retransmit option have
been downloaded, a message
All Targeted Downloads Complete
appears.
The Card Retransmit option is not supported for the M1-3 or QUAD
T1 modules. Downloads may be done to these modules using
option F on the individual module’s Administration Menu with a
direct Craft connection to the desired module.
Targeted downloads take about four minutes each and are
performed sequentially. If more than three modules are targeted
the Craft interface may time out and logoff the user.
Switching over to
the New
Firmware
Try the new firmware by using the B) ACP broadcast switchover
option.
NOTE: When switching over to the new firmware version, there is a
slight chance of failure to switch in one or a few modules.
Check that the switch-over is actually complete. If not, try
again.
Application
Admin. Menu
“F” option
SCM
Card
Retransmit
SCM
Q
U
AD
T1
QU
AD
T
1
M1
-3
Q
U
AD
DA
TA