Deleting nodes, Deleting nodes -8 – Verilink SCM (880-503300-001) Product Manual User Manual

Page 46

Administration Menu

4-8

Verilink SCM

When a remote node is selected, a prompt confirms your selection:

Selected remote node: [0.0.0.3] shelf = 1, slot = 1

Selected remote node: [0.0.0.3] shelf = 1, slot = 1
The remote node’s Main Menu displays.

Figure 4-7 Node Management Menu

NOTE: In the SCM’s Remote End Setup Menu, it is not possible to

know which port on the remote end is supporting the inband.

Duplicate inbands between the same nodes cause a “ringing”

effect. If two circuits connect between the same nodes and

the inband channel fails, then it is possible to enable the

functioning line for inband access.

Deleting Nodes

A node may be deleted from the SCM database by typing “D” and
the node number.

Selected FAR end node: [0.0.0.3] shelf = 0, slot = 1

-- VERILINK SCM CONTROLLER : FW Rev 1.19, Sep 4 1998 13:48:07 --

Site name: Site 10 Access level: 4

Site name: Site 10 Access level: 4
Managing at FAR end node [0.0.0.3] Node id: 17

Managing at FAR end node [0.0.0.3] Node id: 17

<- SLOT ->

<- SLOT ->
SHELF 1 2 3 4 5 6 7 8 9 10 11 12 13

SHELF 1 2 3 4 5 6 7 8 9 10 11 12 13

SHELF 1 2 3 4 5 6 7 8 9 10 11 12 13
0 M [*S] - - Q - Q D - M - - - -

0 M [*S] - - Q - Q D - M - - - -

0 M [*S] - - Q - Q D - M - - - -
1 - - - - - - - - - - - - -

1 - - - - - - - - - - - - -

1 - - - - - - - - - - - - -
2 - - - - - - - - - - - - -

2 - - - - - - - - - - - - -

2 - - - - - - - - - - - - -
3 - - - - - - - - - - - - -

3 - - - - - - - - - - - - -

3 - - - - - - - - - - - - -
4 - - - - - - - - - - - - -

4 - - - - - - - - - - - - -

4 - - - - - - - - - - - - -
KEY: D=QUAD D, I=IMUX, M=M1-3, Q=QUAD T1, S=SCM

KEY: D=QUAD D, I=IMUX, M=M1-3, Q=QUAD T1, S=SCM

S) shelf/slot O) administration

S) shelf/slot O) administration
C) configuration D) diagnostics

C) configuration D) diagnostics

C) configuration D) diagnostics
P) performance/status A) alarm

P) performance/status A) alarm

P) performance/status A) alarm
B) circuit manager I) manufacturing info

B) circuit manager I) manufacturing info

B) circuit manager I) manufacturing info
X) logoff

X) logoff

A [0.0.0.3] [0,1] SCM >