Firmware options, Firmware options -4 – Verilink SCM (880-503300-001) Product Manual User Manual

Page 68

Downloading and Broadcasting Firmware

6-4

Verilink SCM

Figure 6-3 Administration Menu for a Remote Node

Firmware

Options

Command options F, B,and L are not supported at present.
Selecting any of these options will result in a message indicating
that the option is not supported.

Command options on the SCM Administration Menu related to
firmware downloads and control of firmware are shown in

Table

6-1

below:

-- SCM CONTROLLER ADMINISTRATION MENU --

Date/Time/Zone: 09-17-98 01:37:16

Date/Time/Zone: 09-17-98 01:37:16
Node address: [0.0.0.75]

Node address: [0.0.0.75]

Node address: [0.0.0.75]
Node id: 25

Node id: 25

Node id: 25
Site name: site10

Site name: site10

Site name: site10
System uptime: 28:17:55

System uptime: 28:17:55

-- NODE ADMINISTRATION --

H) set shelf_type O) switch over permanent

H) set shelf_type O) switch over permanent
F) firmware from local SCM Q) query firmware

F) firmware from local SCM Q) query firmware

F) firmware from local SCM Q) query firmware
B) download firmware R) reset card

B) download firmware R) reset card

B) download firmware R) reset card
L) TABS download Y) switch over once

L) TABS download Y) switch over once

L) TABS download Y) switch over once
I) change site name P) change password

I) change site name P) change password

I) change site name P) change password
N) TCP/IP parameters X) exit this menu

N) TCP/IP parameters X) exit this menu

A [0.0.0.75] [0,1] SCM >