Verilink SCM (880-503300-001) Product Manual - Manual (Page 21)

Verilink SCM 2-1
Chapter
2
SCM Quick Set-Up
This chapter outlines the basic flow of procedures and options for
getting an SCM up and running.
Installation The SCM boots fastest if it is located in shelf 0, slot 1. Insert the
NIM 3000 first, then the SCM.
Craft Interface Connecting to the Craft interface: see Chapter 3, “Craft Interface” ,
or the Craft Interface Manual .
Administration
Menu
The SCM Administration Menu is used to set the system
parameters, see Chapter 4,
“Administration Menu” .
System Parameters The following parameters must be set before proceeding:
• Shelf type, see page 4-6, “Set Shelf Type”
• Site name, see Table 4-2, “Administration Menu Commands”
• Time/date/zone, see Table 4-2, “Administration Menu
Commands”
• Passwords (optional), see page 4-7, “Using Passwords”
Node Manager Set the node address and node ID see “Administration Menu
Commands” .
SNMP, Telnet, or
SLIP Access
SNMP, FTP or Telnet can be used through an Ethernet or SLIP
connection. If SNMP, Telnet, or SLIP is used to manage the node, set
the TCP/IP parameters. See page 4-10,
“TheTCP/IP Configuration
Menu” .
Configuring
Local Modules
From SCM, Craft, SNMP MoM, or Node Manager, configure the ports
after the system parameters have been set and before building any
circuits.
Circuit Build Build the desired circuits between modules, see Chapter 5, “Circuit
Manager” .