Verilink SCM (880-503300-001) Product Manual - Manual (Page 67)

Downloading and Broadcasting Firmware
Verilink SCM 6-3
Figure 6-2 Administration Menu
Different
Command
Options
Administration Menu options are module-specific, and also
specific to the local or the remote node. For example, the SCM
menu shown above is specific to the local node. The SCM menu
shown in
Figure 6-3 is specific to the remote node.
-- SCM CONTROLLER ADMINISTRATION MENU -- -- SCM CONTROLLER ADMINISTRATION MENU -- -- SCM CONTROLLER ADMINISTRATION MENU -- -- SCM CONTROLLER ADMINISTRATION MENU --
Date/Time/Zone: 09-03-00 05:54:50 Date/Time/Zone: 09-03-00 05:54:50 Date/Time/Zone: 09-03-00 05:54:50 Date/Time/Zone: 09-03-00 05:54:50
Node address: [0.0.0.25]
Node address: [0.0.0.25] Node address: [0.0.0.25] Node address: [0.0.0.25]
Node id: 15
Node id: 15 Node id: 15 Node id: 15
Site name: site10
Site name: site10 Site name: site10 Site name: site10
System uptime: 27:47:11
System uptime: 27:47:11 System uptime: 27:47:11 System uptime: 27:47:11
--- NODE ADMINISTRATION --- --- NODE ADMINISTRATION --- --- NODE ADMINISTRATION --- --- NODE ADMINISTRATION ---
H) set shelf type Z) set time zone H) set shelf type Z) set time zone H) set shelf type Z) set time zone H) set shelf type Z) set time zone
T) set time D) set date
T) set time D) set date T) set time D) set date T) set time D) set date
B) download firmware Y) switch over once
B) download firmware Y) switch over once B) download firmware Y) switch over once B) download firmware Y) switch over once
W) write file to flash O) switch over permanent
W) write file to flash O) switch over permanent W) write file to flash O) switch over permanent W) write file to flash O) switch over permanent
C) set front/rear access Q) query firmware
C) set front/rear access Q) query firmware C) set front/rear access Q) query firmware C) set front/rear access Q) query firmware
A) set node address R) reset card
A) set node address R) reset card A) set node address R) reset card A) set node address R) reset card
I) change site name E) change node id
I) change site name E) change node id I) change site name E) change node id I) change site name E) change node id
N) TCP/IP parameters P) change password
N) TCP/IP parameters P) change password N) TCP/IP parameters P) change password N) TCP/IP parameters P) change password
M) modem parameters S) node selection
M) modem parameters S) node selection M) modem parameters S) node selection M) modem parameters S) node selection
K) show shelf sync_master F) partition copy (B => A)
K) show shelf sync_master F) partition copy (B => A) K) show shelf sync_master F) partition copy (B => A) K) show shelf sync_master F) partition copy (B => A)
X) exit this menu
X) exit this menu X) exit this menu X) exit this menu
A [0.0.0.25] [0,1] SCM > A [0.0.0.25] [0,1] SCM > A [0.0.0.25] [0,1] SCM > A [0.0.0.25] [0,1] SCM >