Main menu options, Main menu options -8 – Verilink SCM (880-503300-001) Product Manual User Manual

Page 30

Craft Interface

3-8

Verilink SCM

The next prompt shows the input format:

Enter 'shelf,slot' pair or 'slot' in current shelf(e.g. 3,4 or 5): >

Enter the shelf and slot location of the module to manage. In this
example, suppose you wish to configure a port on the QUAD T1
located in shelf 1, slot 3. This module is represented by a Q, which
the Key below the shelf/slot display identifies as a QUAD T1. You
would type in response to the prompt:

"1,3".

You may shorten this entry and specify only the slot to select a
module on the current shelf. To go from slot 1 to slot 5 in the
current shelf, enter the following at the prompt:

"5".

When the Main Menu is redisplayed the bracket-indicator ([ ]) has
moved to enclose the Q.

Figure 3-3 SCM Main Menu for QUAD T1

The command-line prompt reflects your selection in the shelf and
slot field (Shelf 1, Slot 3 in this case) and the module type
displayed in the command line (QUAD T1).

Main Menu Options

This section provides a brief description of selections on the Main
Menu.

-- VERILINK SCM CONTROLLER : FW Rev 1.29, Nov 13 1998 16:53:13 --

Site name: SCM Tutorial Access level: 2

Site name: SCM Tutorial Access level: 2
Managing at NEAR end node [0.0.0.2] Node id: 122

Managing at NEAR end node [0.0.0.2] Node id: 122

<- SLOT ->

<- SLOT ->
SHELF 1 2 3 4 5 6 7 8 9 10 11 12 13

SHELF 1 2 3 4 5 6 7 8 9 10 11 12 13

SHELF 1 2 3 4 5 6 7 8 9 10 11 12 13
0 - - - - - - - - - - - - -

0 - - - - - - - - - - - - -

0 - - - - - - - - - - - - -
1 M *S - [Q] Q I M D - - - - - -

1 M *S - [Q] Q I M D - - - - - -

1 M *S - [Q] Q I M D - - - - - -
2 - - - - - - - - - - - - -

2 - - - - - - - - - - - - -

2 - - - - - - - - - - - - -
3 - - - - - - - - - - - - -

3 - - - - - - - - - - - - -

3 - - - - - - - - - - - - -
4 - - - - - - - - - - - - -

4 - - - - - - - - - - - - -

4 - - - - - - - - - - - - -
KEY: D=QUAD D, I=IMUX, M=M1-3, Q=QUAD T1, S=SCM

KEY: D=QUAD D, I=IMUX, M=M1-3, Q=QUAD T1, S=SCM

S) shelf/slot O) administration

S) shelf/slot O) administration
C) configuration D) diagnostics

C) configuration D) diagnostics

C) configuration D) diagnostics
P) performance/status A) alarm

P) performance/status A) alarm

P) performance/status A) alarm
B) circuit manager I) manufacturing info

B) circuit manager I) manufacturing info

B) circuit manager I) manufacturing info
R) remote end setup

R) remote end setup

R) remote end setup
X) logoff

X) logoff

A [0.0.0.2] [1,3] QUAD T1 >