Verilink SCM (880-503300-001) Product Manual - Manual (Page 41)

Administration Menu
Verilink SCM 4-3
Table 4-1 Administration Menu Commands
Menu Option Description Instructions
H) set shelf type Define or change shelf types of each
shelf in local node.
See the subsection: “Set Shelf Type” .
T) set time Sets time for all modules in the node. Use format hh:mm:ss to set time. Set
the time zone, then date, and then
time. This order is important.
B) download firmware Firmware download to selected
modules (other than the SCM itself).
See Chapter 6, “Downloading and
Broadcasting Firmware” .
W) write file to flash Stores previously downloaded firmware
in flashbank on this SCM card.
See Chapter 6, “Downloading and
Broadcasting Firmware” .
C) set front/rear access Set management port access. Front or back, not both at same time.
The default is front access.
A) set node address Changes local node address. This is not
the Ethernet IP address. This is the
prompt line address [0.0.0.1]. The
value for each SCM must be unique.
Never set first octet greater than 127.
Will cause momentary reset of SCM as it
updates database records. Used by
Verilink Node Manager application.
I) change site name Changes local node site name as it
appears on second line of Main Menu.
Enter up to 19 alpha-numeric
characters.
N) TCP/IP parameters Ethernet/SLIP, SNMP, Trap Host, and
TCP/IP addresses and options.
See the section: “TheTCP/IP
Configuration Menu” .
M) modem parameters SCM SLIP modem interface menu. See the section: “Configuring Modem
Parameters” .
K) show shelf_master Displays which module is driving the
backplane sync clock.
Reference information for Technical
Support. See AS3000: the Basics,
Chapter 2, “System Information”, for
further details.
X) exit this screen Exits to SCM Main Menu.
Z) set time zone Set time zone for all modules in node. Select time zone from list presented, or
use custom for GMT offset in hours +/-.
Enable/Disable Daylight Savings option.
Set the time zone, then date, and then
time. This order is important.
D) set date Set date for all modules in node. Use the format: mm/dd/yy for month,
day, and year. Set the time zone, then
date, and then time. This order is
important.
Y) switch over once Executes selected firmware image
ONCE. The switchover is not
permanent. Use to test firmware
upgrades.
See Chapter 6, “Downloading and
Broadcasting Firmware” .
O) switch over
permanent
Sets which flash bank to boot from at
power up (setting saved on reset).
See Chapter 6, “Downloading and
Broadcasting Firmware” .
Q) query firmware Displays status of firmware revisions in
partition banks of selected module.
Results displayed after about 60
seconds.