Verilink SCM (880-503300-001) Product Manual - Manual (Page 61)

Circuit Manager
Verilink SCM 5-7
When building circuits, you may need to separately activate the
circuit by selecting the command:
I) activate circuit from the
Circuit Manager Menu.
Editing and Cloning New Circuits
This section describes how to edit an existing circuit. Time savings
are possible when creating new circuits by “cloning” an existing
circuit.
Begin to edit a circuit by typing "E" at the Circuit Manager Menu:
[127.127.127.67] [0,1] SCM > e
You are prompted to enter the name of the circuit to edit.
The Edit Circuit Menu appears with the configuration of the
specified circuit:
ST Source Mapping: timeslots to use at
the Source Port. For T3 ports these
are level 1 (DS1) timeslots — at T1
rate each.
Note: applies to M1-3 only.
Enter the timeslots with
comma separators or a
range with a hyphen
between first and last.
For example: 1,2,3,4 or
1-4.
1-28 for T3 ports.
DM Destination Mapping: timeslots to use
at the Destination Port. For T1 ports
these are level zero (DS0) timeslots at
56K or 64K each.
Note: applies to QUAD T1 only.
Enter the timeslots with
comma separators or a
range with a hyphen
between first and last.
For example: 1,2,3,4 or
1-4.
1-24 for T1 ports.
DT Destination Mapping: timeslots to use
at the Destination Port. For T3 ports
these are level 1 (DS1) timeslots — at
T1 rate each.
Note: applies to M1-3 only.
Enter the timeslots with
comma separators or a
range with a hyphen
between first and last.
For example: 1,2,3,4 or
1-4.
1-28 for T3 ports.
S Setup: used to start a fully-configured
circuit. All parameters above should
be entered first before setup is
invoked.
When Setup command is
issued Circuit Manager
will attempt to route and
initialize the circuit.
After a brief pause the
menu is redisplayed with
the status of the circuit
shown.
Should a circuit fail to
become active, check the
configuration of the
application module(s) and
verify ports used are
configured as active ports.
X Exit: return to Circuit Manager Menu. If the Add Circuit Menu is
exited before completing
a circuit, the incomplete
circuit is lost.
Key Description Range Note