Verilink SCM (880-503300-001) Product Manual User Manual

Page 71

Downloading and Broadcasting Firmware

Verilink SCM

6-7

options. If the address of the FTP server reflects a different
network segment than the SCM, also verify that the gateway
address reflects a valid router port.

Using FTP to

Transfer the File

Once PING is successful, connect to the FTP server:

ftp 192.94.45.242

and then log in to the FTP server using whatever method your FTP
server package may require.

Navigate to the directory on the FTP server where you placed the
new download file. Typically this is done using the cd command:

cd mydir

Issue the binary command to set the transfer type to binary:

binary

Transfer the file to the SCM module by using the Get command:

get flash.qb flash.qb

NOTE: As with the copy command, the first instance of "flash.qb" in

this command is the source, the file on the FTP server, and

the second instance of "flash.qb" is the target or name under

which it is to be saved in RAM on the SCM. Be sure that you

do save the file as "flash.qb", regardless of its name on the

FTP server.

You should see screen output like:

200 PORT command successful.
150 Binary data connection for flash.qb (192.94.45.229,1026)

(584121 bytes).

The file transfer is likely to take a few minutes, after which a
message appears:

226 Transfer complete.
584121 bytes received in 36 seconds (15 Kbytes/s)

Writing the File to

Flash Memory

Once the transfer is finished, end your FTP session by typing
“quit”.

You will be returned to the pSH+> prompt.

At the shelf/slot map select:

O) administration