Verilink SCM (880-503300-001) Product Manual - Manual (Page 24)

Craft Interface
3-2 Verilink SCM
2. Set your terminal parameters to the following values:
• 19.2 kbit/s
• 8 data bits
• no parity
• one stop-bit
• no flow-control
NOTE: Ensure that both hardware flow control and X-On/X-Off flow
control are disabled.
3. Press E NTER to get a prompt.
The prompt displays:
pSH+>
The P-shell is a level below the Craft interface program.
4. To start the Craft interface, type:
“craft”
5. You are prompted:
YOUR PASSWORD?
6. If you’re accessing the node for the first time, press E NTER at
the PASSWORD? prompt.
Until you change it, E NTER is the default password.
Using Telnet Accessing the SCM Craft interface via Telnet requires that you have
previously configured the Ethernet IP address and related
parameters. The Craft interface of the local port must be used at
least once to set up the IP address of the SCM before Telnet can be
used.
In a shell, terminal, browser, or Telnet application window, use a
command similar to the following:
C:\> telnet 192.94.46.54 (use the SCM IP address)
A message indicates you have connected to the SCM node:
Figure 3-1 Telnet Session Connecting to the SCM Node
Trying 192.94.46.54 ... Trying 192.94.46.54 ... Trying 192.94.46.54 ... Trying 192.94.46.54 ...
Connected to 192.94.46.54.
Connected to 192.94.46.54. Connected to 192.94.46.54. Connected to 192.94.46.54.
Escape character is '^]'.
Escape character is '^]'. Escape character is '^]'. Escape character is '^]'.
pSOSystem (192.94.46.54)
pSOSystem (192.94.46.54) pSOSystem (192.94.46.54) pSOSystem (192.94.46.54)
Copyright (c) Integrated Systems, Inc., 1992.
Copyright (c) Integrated Systems, Inc., 1992. Copyright (c) Integrated Systems, Inc., 1992. Copyright (c) Integrated Systems, Inc., 1992.
Welcome to pSOSystem...
Welcome to pSOSystem... Welcome to pSOSystem... Welcome to pSOSystem...
pSH+>
pSH+> pSH+> pSH+>