MultiDyne ACI-2058 - Manual (Page 25)

I NTELLA P ATCH Switches: ACI-2058 User Manual
A54-2058-000 21 A PCON , Inc.
3. Insert the back of the blade into the guides on each side of the slot.
4. Holding the blade straight, slide it into the guides as far as it will go.
Figure 9. Inserting a Blade
Guide
Thumbscrew
Guide
Thumbscrew
5. Press the blade into the chassis as you turn the thumbscrews to secure the blade
in place.
The ACI-2058 automatically detects that the blade is in place and powers on the blade.
5.2. Transceiver Modules
5.2.1. Removing SFP Transceiver Modules
To remove a transceiver module:
• Nonbail type:
Carefully push the ejector pin in while pulling out the module.
• Bail type:
Pull the bail down and pull out the module.
5.2.2. Installing SFP Transceiver Modules
To insert a transceiver module:
• Nonbail type:
1. Hold the module by the housing, so that the label faces up.
2. Insert the module into the socket until you hear or feel a slight click.
• Bail type:
1. Close the bail latch if it is currently open.
2. Hold the module by the housing, so that the label faces up.
3. Insert the module into the socket until you hear or feel a slight click.
5.2.3. Handling and Installing Fiber Optic Cables
To extend the life of transceiver modules, use caution when handling and installing cables.
Do not remove the dust cover until immediately prior to mating the cable. To ensure proper
cable mating, complete the steps in the following procedures.