Appendix b – tcp/ip and resource tests, Appendix b – tcp/ip and resource tests b, Before you run a test – Measurement Computing StrainBook/616 User Manual
Page 139: How to run the tcp/ip test
Appendix B – TCP/IP and Resource Tests B
Before you run a test
Before testing the system, make sure the StrainBook has been properly installed and powered-on.
Make sure all cables are properly and securely connected.
When testing a StrainBook, if the unit does not respond within 30 seconds perform the
following steps:
1) reboot the system
2) upon power-up, re-open the Daq Configuration applet
3) select another configuration setting
4) reinitiate the test
How to run the TCP/IP Test
(The TCP/IP test is for Ethernet devices only)
The TCP/IP (Transmission Control Protocol/Internet Protocol) test is accessed and initiated as follows.
a. Open the Control Panel by navigating from the Windows Desktop:
Start Menu ⇒ Settings ⇒ Control Panel
b. From the Control Panel, double-click the Daq Configuration icon.
c. Select the StrainBook from the Device Inventory configuration tree.
d. Click the <Properties> button. The Properties dialog box will open.
e. Click the “Test Hardware” tab.
f. Click the <TCP/IP Test> button.
Results of a TCP/IP Test for a
StrainBook/616
Appendix B
977194
TCP/IP and Resource Tests for StrainBook B-1