Gasboy CFN Series CFN II Quick Reference - Manual (Page 8)

CFN II Quick Reference
4 C09159 Rev. 2238
operation.
Options: CI
I
option enables and re-initializes all TMSs
EXit (27) exits command mode, enters system
monitor mode; if the exit command is in a command
file, the system prompt returns.
FIND disk-based command to search for pattern in
files.
Options: [;[A][I]] pattern file1 [file2] ...
;A prints line numbers along with lines
;I returns the number of lines on which pattern
is found (%E)
FIX_CONF disk-based command to update an old
configuration file to work with a new release of
FRAMOS (but not a new version number).
Options: [-Dconf_name]...[filename]
-Dconf_name conf_name is replaced with name
of configuration program to be reset to
defaults (e.g., READER, PUMP,
SYS_PAR) or ALL for all configuration
programs at once; you may specify more
than one program by repeating modifier in
front of the name of each configuration
program you want to reset to its default
filename name of configuration file; if no file
name is given, assumes FRAMOS.CFG
Fix TRansactions (28) changes transaction-begin
and -end pointers.
Options: AI rec1 rec2
A recalculate CRC; allows damaged
transaction records to be used; use only if
necessary to allow corrupted records to be
polled
I clear all transaction numbers from the
transaction file and reset the transaction
pointers; irreversible; fill transaction number
field with -1s for all transactions
rec1 rec2 set pointers; rec1 is the physical
record number of the oldest transaction you
want to include in the active portion of the
table; rec2 is the physical record number of
the most recent transaction you wish to
include in the active portion of the table
fmtlint a shift-change command to output memory
utilization to the screen.
Options: [filename]
FORMAT (116) formats a floppy or RAM disk.
Options: [A | B | D] [4 | 5]
A, B, D drive of disk to be formatted
4, 5 use 4 for a 720K floppy; 5 for 1.4M
FRED disk-based full-screen text editor (FRED
commands are summarized later in this chapter).
Option: [filename]
FUELER disk-based program to set the fueler ID for
a cluster.
Options: [ ]
If the arguments are not provided, the current
state of all fuelers is shown. Only clusters 1-
9 can have a fueler. Entry of a Fuel ID card
generates a disk journal event type 197 with
the first two characters of the text field
containing the cluster number.
Fuelpt disk-based configuration program for fuel
point readers.
Options: [-P][-V] [filename]
-P print current configuration
-V display in TTY form if port is configured as
a CRT in the system parameters, or vice
versa
GATE disk-based gate-reader configuration
program.
Options: [-P][-V] [filename]
-P print current configuration
-V display in TTY form if port is configured as
a CRT in system parameters, or vice versa
Get TRansactions (117) polls transactions from
connected site.
Option: A
A option prints full Print Transaction format
GOTO used in command files; execution jumps to
line labeled with label.
Option: label
HARD disk-based command to format hard disk.
Options: I | F [skew]
I
initialize file system
F [skew] format hard disk, then initialize; skew
is the interleave factor; default is 0
HARDBACK disk-based command to back up
program, command, configuration, and hard-disk
system files to floppy diskettes.
HARDLOAD disk-based command to restore data
backed up with the HARDBACK command.
Help (29) lists Site Controller commands.
Option: A
A option prints commands with command
numbers