Gasboy CFN Series CFN II Quick Reference - Manual (Page 38)

CFN II Quick Reference
34 C09159 Rev. 2238
Test Mode
To activate test mode, open the island card reader
door, flip the S3 switch on the CPU board to TEST,
and press START OVER on the keypad. (The unit
must remain open during tests.) The keypad is now
enabled for selecting one of the 9 test routines:
1 test front panel lights for paper low and paper
out on receipt printer
2 test the table messages
3 test printer
4 test DES
5 test alphanumeric display
6 test keypad
7 test card reader (mag or optical)
8 display baud rate and address
9 test paper cutter
Printers
Novatronics
There is only one jumpered connection on the
Novatronics board. With the board oriented so that
the DB-25 connector is at the top left, the jumper
block is below the connector; jumper the two
rightmost pins to set the baud rate at 9600.
Star
There are two DIP switch banks on the Star printer.
Each position must be set as follows:
DIP Switch Bank 1
Position & Definition Required Setting
1-3 9600 baud on
4 stop bit 1 on
5 X-on/X-off mode off
6 8 data bits on
7 no parity on
8 even parity off
DIP Switch Bank 2
Position & Definition Required Setting
1 USA character set on
2 USA character set on
3 printer type on
4 CR valid off
Island Card
Reader II
CPU Board
Part number: C05857.
Works with program software 5.0 and above.
Notes
Beckman display not supported
Motorized reader not supported
Novatronics printer not supported
Switches
DIP Switch Bank
DIP switch on the reader terminal CPU board sets
options, including the reader terminal address:
Position & Definition Setting(*=customary)
1 not used not used
2 decimal point *open=enable
closed=disabled
3 1 or 2 line display *closed=1 line
open=2 line
4 reader type see below
5 gate reader *open=disabled
closed=enabled
6 reader type see below
7-10 address see below
Reader Type 4 6
mag swipe without optical closed closed
mag swipe with optical closed open
mag insert open closed
optical closed open