Gasboy CFN Series CFN II Quick Reference - Manual (Page 19)

CFN II Quick Reference
C09159 Rev. 2238 15
SYS_PAR disk-based configuration program for
system parameters; main configuration program for
Site Controller.
Options: [-P][-V] [filename]
-P print current configuration
-V display in TTY form if port is configured as
a CRT in the system parameters, or vice
versa
TABLE disk-based configuration program for data
table sizes.
Options: [-P][-V] [filename]
-P print current configuration
-V display in TTY form if port is configured as
a CRT in the system parameters, or vice
versa
TAX disk-based tax table entry program.
Options: [;[C][I]] [-P | -R | -?]
;C chain entries: keep looping back to the
initial prompt
;I reconstruct the tax rate table
-P print tax table summary
-R print tax table in raw form used by
RESTORE
-? run in tutorial mode
TEst PCu (73) tests a pump control unit’s memory.
TRANBACK disk-based command to back up
transaction data to the TRANBACK.DTA file.
TREE disk-based command to print directory
structure.
TRFMT disk-based configuration program for local
transaction format.
Options: [-P][-V] [filename]
-P print current configuration
-V display in TTY form if port is configured as
a CRT in the system parameters, or vice
versa
TYpe (5) prints the contents of a file.
Option: A
A option prints past the MS-DOS end-of-file
marker
Unlock CArd (74) validates a card.
Options: CA
A option clears card file and sets negative
lockout
variable a shift-change command to list the state of
the shift sequence and shift number for the system
and for each console.
WHERE disk-based command to print the current
directory.
WOW disk-based command to display recent
history and transactions-in-progress data
simultaneously; for CRT only.
Option: [-H]
-H do not display history
FRED Command Summary
Modes
Command Mode Function
^E i e c enter edit mode
^C i e c enter command mode
^N i e c enter insert mode
Insert or Edit Mode
Command Argu Mode Function
^O i e open line above
ENTER key i e open line below
↑ or ^K i e cursor up one line
↓
or ^J i e cursor down one line
← or ^H i e cursor left one character
→
or ^L i e cursor right one character
SPACEBAR E cursor right one character
b E move cursor to beginning of line
e E move cursor to end of line
c E enter command mode
i E enter insert mode
DEL key i e delete one character left of cursor
^D i e delete one character at cursor
^X i e delete current line
k char e
kill line from cursor up to character
char
^U i e undo changes to current line
^S i e split line at cursor
^R i e join current line to line above
^Y i e save current line
^P i e put saved line below current line
u e scan backward (up) through file
d e scan forward (down) through file
g n e c go to line number n
x char e
exchange character at cursor with
character char
s char e search for character char