Gasboy CFN Series CFN II Quick Reference - Manual (Page 31)

CFN II Quick Reference
C09159 Rev. 2238 27
CPU Board, Firmware 5.3 & 5.4
CPU board assembly number: C05836.
There are no DIP switch banks on the Check Point
CPU board with this firmware version.
Pins 2 and 3 on K1 (next to U15) are normally
jumpered.
Any RS-232 (serial) printer connected directly to the
Check Point CPU board goes to P11; a parallel
printer goes to P12.
Check Point Test Mode
To begin a self test:
• turn keyswitch to MANAGER and press 00/NO
SALE, or
• disconnect the RS-422 connector, wait for the
Out of Service display, and press 00/NO SALE.
0 self-test
1 memory test
2 beeper check
3 console card reader test
4 display test
5 keyboard test
6 test opening of cash drawer
7
check setting of switches (firmware 5.2) or
configuration (firmware 5.3)
8 serial port/loopback test
CLEAR PRINT printer test (ver. 5.4 and higher)
9 ends self test
00 manager key test (firmware 5.3 or later)
Configuration
In the self test with firmware 5.3, pressing 7 accesses
configuration mode. (If the Check Point has never
been configured or if its configuration has been
erased, it will go into configuration mode at power
up.)
The default selection is the first selection shown in
each of the following option groups:
Option Menus Selections
console address 1 2 3 4
keyswitch type 4 position
2 position
cash drawer yes no
drawer switch type dr clo=sw closed
dr clo=sw open
beeper enabled disabled
alert beep type short long no no
alert beep repetition* 15 sec 8 sec
4 sec 2 sec
key click type short medium
long none
LED color normal reversed
dead man timer on off
console printer/pad** No CONS PRNT/Pad
Console PRNT/Pad
printer address 01 01-64
DES disabled enabled
receipt line feed, top 0 1-10
receipt line feed, end 10 00-18
receipt left margin 04 00-10
printer Star undefined
printer port serial parallel
decimal position .00 none .0 .000
decimal point period comma
ignore scan 57 36-59, 62-77, 99
ignore scan 99 36-59, 62-77, 99
ignore scan 99 36-59, 62-77, 99
ignore scan 99 36-59, 62-77, 99
ignore scan 99 36-59, 62-77, 99
* in version 5.3e
** for Star RS-422 printer, set to No CONS PRINT/Pad
While an option in each group is displayed, pressing:
• ENTER selects the currently displayed option
and causes an option in the next group to display.
• 1 selects the next option in that group.
• 2 defaults to the first option in that group.
• 0 exits configuration mode and saves your
changes.
• PREV selects the currently displayed option and
displays the previous group.
• 7 returns you to the initial configuration display.