Gasboy CFN Series CFN II Quick Reference - Manual (Page 37)

CFN II Quick Reference
C09159 Rev. 2238 33
If an Okidata printer is not directly connected and if
you have a Site Controller II version 1.0F or above,
you may set Print Mode to Normal and set
SYS_PAR’s Direct Printout Channel to Aux-o. This
combination sends printout to the Okidata logger; the
printout is not seen on the screen.
Any commands run at the Site Controller will not be
logged unless you:
• direct output to the logger (use >log with the
command), or
• press CONTROL - SHIFT - PRINT SCREEN
simultaneously. Pressing these keys toggles the
Main port output to the logger. (The message
line at the top of the screen toggles between FDX
MAIN and FDX AUX.)
All other parameters should be set as shown above.
Island Card
Reader I
CPU Board
Part number: C05375.
Switches
DIP Switch Bank 2
DIP switch 2 on the reader terminal CPU board sets
options, including the reader terminal address:
Position & Definition Setting(*=customary)
1 see below *open
2 decimal point *open=enable
closed=disabled
3 DES PIN encryption *closed=disabled
open=enabled
4 reader type see below
5 gate reader *open=disabled
closed=enabled
6 reader type see below
7-10 address see below
Reader Type 2-4 2-6
mag swipe without optical closed closed
mag swipe with optical closed open
mag insert open closed
optical closed open
Notes
Position 2-1 is not used in SC II software versions
1.0 and later. (In software versions 0.2 and before, 2-
1 is the deadman timer switch: open
(default=enabled, closed=disabled.)
Position 2-5—In SC II software versions 0.2 and
before, 2-5 is the CRC switch; open=CRC enabled,
closed= disabled.
Address 2-7 2-8 2-9 2-10
1 cl cl cl cl
2 cl cl cl op
3 cl cl op cl
4 cl cl op op
5 cl op cl cl
6 cl op cl op
7 cl op op cl
8 cl op op op
9 op cl cl cl
10 op cl cl op
11 op cl op cl
12 op cl op op
13 op op cl cl
14 op op cl op
15 op op op cl
16 op op op Op
Jumpers
Jumper Function and/or Normal Setting
K1 Position 1=LCD display
Position 1 and 2=Beckman alphanumeric display
K2, K3 K2 in position 2 and K3 in position 1=Omron reader
K2 in position 1 and K3 in position 2=Magstripe reader
K4 ____
K5 Position 2=2K RAM; position 1=8K RAM
K6 Jumpered when using motorized reader