Daktronics All Sport 5100 Timer - Manual (Page 9)

All Sport 5100 Operation 1-1
Section 1: All Sport 5100 Operation
This manual explains the setup and operation of the All Sport
®
5100 Auto Racing
Control Console. For questions regarding the safety, installation, operation or
service of this system, please refer to the telephone numbers listed on the cover page
of this manual.
1.1 How To Use This Manual
Daktronics identifies manuals by their engineering document number, or ED
number, which is located on the cover page. Any supplemental manuals referenced
in this manual will be identified by their ED numbers. This manual, for example,
would be referred to as ED-12501.
Daktronics sales literature is identified by an SL number in one of the lower corners
of each page. Typically, the SL prefix, a zero and the last four digits of the number
are used for identification, as in SL02345.
The box at right illustrates the Daktronics drawing numbering system. The drawing
number is located
in the lower-right
corner of the drawing
label (in the example,
7087-P08A-69945).
Drawings in this
manual are referenced
by their last set of
digits and the letter
preceding them. In
Figure 1, the drawing
would be referred to as Drawing A-69945. Drawings are grouped and inserted in
alphanumerical order in Appendix A.
1.2 Introduction
This section explains the operation of the All Sport 5100 Auto Racing Control
Console, which is part of the Daktronics All Sport 5000 Series family of display
controllers.
Important Safeguards
1. Read and understand these instructions before installing your console.
2. Do not drop the control console or allow it to get wet.
3. Do not let power cords touch hot surfaces or hang over the edge of a table
or other surface where they might be damaged or cut.
4. If an extension cord is necessary, use a three-prong, polarized cord.
Arrange the cord with care so that event personnel or spectators cannot trip
over it or pull it out.
Figure 1: Daktronics Drawing Label