Daktronics All Sport 5100 Timer - Manual (Page 17)

All Sport 5100 Operation 1-9
(Continued from previous page)
LCD Display Action
Channel Setting
0- Broadcast Channel for this Broadcast Group
BCAST = 0 – Master Broadcast (all radios)
BCAST = 1 – Broadcast Group 1
BCAST = 2 – Broadcast Group 2
1-4 Channels that may be used within Broadcast
groups 1 or 2 (BCAST = 1 or BCAST = 2.)
5-8 Channels that may be used within Broadcast
group 1 only (BCAST = 1.)
Radio Channel Setting: Single Controller Systems
Typically all Single Controller systems will use the default setting BCAST = 1,
CHAN = 1. All radio receivers must be set with a switch setting of 1 with the
Broadcast 1 (BCAST 1) jumper set.
If you suspect interference from a nearby Daktronics system, press at the
“RADIO SETTINGS” prompt to change the channel number.
Typically all Multiple Controller systems will use channel 1 for the first controller.
All other controllers will use sequential channel settings (2-8)
LCD Display Action
The LCD will toggle
these screens
The bottom line shows
default settings.
RADIO SETTINGS
BCAST Y CHAN XX
Enter to accept
clear to modify
bcast group 1
radio chan 01
The LCD shows the current radio settings along
with a prompt to accept or modify these values.
If the radio settings are correct, press <ENTER>.
If these values are incorrect, press <CLEAR>
If <CLEAR> is pressed to modify the radio
settings, the LCD at the left is shown, allowing
edit of the Channel or Broadcast group setting.
Edit the Broadcast Setting. Use the number keys
to enter the desired broadcast group and press
<ENTER> to accept.
(Continued on following page)