3 test mode – Daktronics All Sport 5100 Timer User Manual
Page 67
Drag Racing Interface
7-3
Bit Value
Description
MSB
80
Always 0
40
Always 0
20
Always
1
10
Display Brightness: 0 = Bright, 1 Dim
08
True Win: 0=Off, 1=On
04
First to Finish: 0=Off, 1=On
02
Break Out: 0=Off, 1=On
LSB
10
Foul: 0=Off, 1=On
Bits 08H, 04H, 02H, and 01H are included in the protocol for those scoreboards that
have indicators for these items.
NOTE: '04', Byte 13, can also be as follows:
Bit Value
Description
MSB
80
Always 0
40
Always 0
20
Always
1
10
Always 1
08
Always 0
04
ET Line Elapsed Time DP
02
MPH Line Elapsed Time DP (Left DP)
LSB
01
MPH Line Speed DP (Right DP)
Bits 04H, 02H, 01H are included in the protocol for those scoreboards that have
indicators for these items.
7.3 Test
Mode
Reference Drawing:
Insert; CompuLink Interface ...............................................Drawing A-164750
The console has built in test functions for the data input and the scoreboard output.
These tests will help isolate system problems and verify proper operation.
To test the scoreboard output, press the <
ALL ON
> test and the <
NUMBER TEST
>
keys. When pressed, these keys will put the specified pattern on the scoreboard.
To test the data input, use the <
LOOPBACK…
> test keys. Refer to Drawing A-
164750. Pins 2 and 3 of J6 on the All Sport 5100 console will need to have an
electrical connection made between them. To make this connection, place a bent
paper clip or a similar wire from pin 2 to pin 3 of J6. When this is done, pressing any
of the loopback keys will send that data out on pin 3 of J6 on the console. The data
should show up on the scoreboard. If this test works, then the data input on the
console is functional.