Comtech EF Data CDM-740 - Manual (Page 69)

CDM-740 Advanced Satellite Modem Revision 0
Front Panel Operation MN-CDM740
5–17
Note the following:
Selection Description
Auto
The port will auto-negotiate the configuration of the port (recommended
when the configuration of the port is unknown)
1000F 1000 Mb / Full Duplex
100F 100 Mb / Full Duplex
100H 100 Mb / Half Duplex
10F 10 Mb / Full Duplex
10H 10 Mb / Half Duplex
(CONFIG:) IP Æ (GE1 / GE2 / MGMT) Æ NegoSpeed
[HEADER] Negotiated Speed (read-only)
Down 1000F 100F 100H 10F 10H
( ◄► E)
Where [HEADER] is GE1, GE2, or MGMT( MANAGEMENT): This is a ‘status only’ display
showing the negotiated line speed and duplex setting for this interface. Exit this read-only screen
by pressing ENTER or CLEAR.
Note the following:
Selection Description
Down Ethernet is disconnected
1000F 1000 MB / Full Duplex
100F 100 MB / Full Duplex
100H 100 MB / Half Duplex
10F 10 MB / Full Duplex
10H 10 MB / Half Duplex
5.4.5.2 (CONFIG:) IP Æ (SNMP) Read-Cmty
SNMP Read Community (Max 15 chars)
[public ] (
◄► E)
To edit the SNMP Read Community string, use the ◄ ► arrow keys to select the character to edit,
then use the
▲ ▼ arrow keys to select the desired character.
Note: Only the first 15 characters on the bottom line are available.
All printable ASCII characters are available with the exception of the backslash (ASCII code 92)
and ~ (ASCII code 126).
Once the string has been composed, press ENTER. All trailing spaces are removed from the
Read Community string upon entry.