Comtech EF Data CDM-740 - Manual (Page 103)

CDM-740 Advanced Satellite Modem Revision 0
Ethernet Management MN-CDM740
6–19
Add PID
This section permits the user to create Rx Routes. A configured PID value, in hexadecimal
format, is required for MPE/IP data to be extracted from the transport stream and sent to the
CDM-740 CPU. Once a valid PID value is configured and data is found on a transport stream, the
data is decapsulated and delivered to the traffic port.
Type: Presently, MPE/IP is the sole available interface mode.
PID (Hex): Enter a valid PID, in hexadecimal format ranging from 0x10 to 0x1FFE, in this box.
Entering 0x1FFF disables the entry. (Note: This PID value cannot be used or defined elsewhere
on the CDM-740 for carrying user data traffic.)
Eth Out: Use the dropdown menu to select GE1 or GE2 as the port to be used when routing the
Transport Stream over Ethernet IP.
Once the PID has been defined, click [Add Rx Route] to finish.