Comtech EF Data CDM-740 - Manual (Page 137)

CDM-740 Advanced Satellite Modem Revision 0
Remote Control MN-CDM740
A–23
A.5.7 BUC Parameters (L-Band Device)
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to Query
BUC
Current
High Limit BCH=
4 bytes Command or Query.
Sets or returns the BUC Current High Limit in the form xxxx, where:
xxxx = a value between 0 and 4000mA, in 100mA increments
BCH=
BCH?
BCH*
BCH# BCH?
BCH=xxxx
(see Description of
Arguments)
BUC
Current
Low Limit BCL=
4 bytes Command or Query.
Sets or returns the BUC Current Low Limit in the form xxxx, where:
xxxx = a value between 0 and 4000mA, in 100mA increments.
BCL=
BCL?
BCL*
BCL# BCL?
BCL=xxxx
(see Description of
Arguments)
BUC
DC
Current N/A 4 bytes Query only.
Returns the value of the BUC DC current in the form xxxx, where:
xxxx = a value, in mA, between 0 and 9999.
If not available, response is 0000.
N/A BDC? BDC=xxxx
(see Description of
Arguments)
BUC
Voltage N/A 4 bytes Query only.
Returns the value of the BUC Voltage in the form xx.x, where:
xx.x = a value, in volts, between 0 and 64.0
N/A BDV? BDV=xx.x
(see Description of
Arguments)
BUC
10 MHz
Reference BFR=
1 byte Command or Query.
BUC 10 MHz Reference control, where:
0=Off
1=On
BFR=
BFR?
BFR*
BFR# BFR?
BFR=x
(see Description of
Arguments)
BUC
Power Supply
enable BPS=
1 byte, value of 0
or 1 Command or Query.
BUC Power Supply control, where:
0=Disable the BUC DC Power Supply
1=Enable the BUC DC Power Supply
BPS=
BPS?
BPS*
BPS# BPS?
BPS=x
(see Description of
Arguments)